USER’S INFORMATION MANUAL - Bryant 311A Manual

USER’S INFORMATION MANUAL - Bryant 311A Manual

Sponsored Links

311aav, 312aav Downflow/horizontal Upflow Gas Furnace Manual Summary


Search in this Manual:

USER’S INFORMATION MANUAL - Page 1

MODEL 311AAV and 312AAV DOWNFLOW/HORIZONTAL/ UPFLOW GAS FURNACE NOTE TO INSTALLER: This manual must be left with the equipment user. Multipoise USER’S INFORMATION MANUAL — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. — WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, cal..

MODEL 311AAV and 312AAV - Page 2

2 WELCOME TO TODAY’S GENERATION OF COMFORT Congratulations! Your new, higher efficiency gas furnace is a sound investment which will reward you and your family with years of warm memories winter after winter. Not only is your new furnace energy efficient, it is also ex- tremely reliable. Spend just a few minutes with this booklet to learn about the operation of your new furnace—and the small amount of maintenance it takes to keep it operating at peak efficiency. Years went into the development of your new furnace. Take a little time now to assure its most efficient operation for years t..

WARNING - Page 3

3 IMPORTANT FACTS Your furnace must have adequate air- flow for efficient combustion and safe ventilation. Do not enclose it in an airtight room or “seal’’ it behind solid doors. To minimize the possibility of serious personal injury, fire, damage to your furnace, or improper operation; carefully follow these safety rules: • Keep the area around your furnace free of combustible materials, gasoline, and other flammable liquids and vapors. 3 • Do not cover the furnace, store trash or debris near it, or in any way block the flow of fresh air to the unit. • Combustion air must be..

STEPS FOR STARTING - Page 4

4 STEPS FOR STARTING YOUR FURNACE 1. Set your room thermostat to the lowest temperature setting. (See Fig. 5.) 2. Close the external manual gas valve. (See Fig. 6.) 3. Turn OFF the electrical supply to your furnace. (See Fig. 7.) 6 7 8 4. Remove the outer door by remov- ing two screws. (See Fig. 8.) 5. The gas valve will have a control switch to turn off and on. Turn the control switch on the gas valve to the OFF position and wait 5 min- utes. (See Fig. 9.) 6. After waiting 5 minutes, turn the control switch on the gas valve to the ON position. (See Fig. 10.) 7. Replace the outer door using..

If your furnace filter needs replacing, be - Page 5

5 lockout. If lockout occurs, or the blower doesn’t come on—shut down your furnace and call your dealer for service. 12. Set your thermostat to the tempera- ture that satisfies your comfort re- quirements. SUGGESTION: Setting the thermostat back a few degrees—and compensating for the difference with warmer clothing— can make a big difference in your fuel consumption on extremely cold days. The few degrees at the top of your thermostat “comfort level’’ are the most costly degrees to obtain. When the room temperature drops below the temperature selected on the thermostat, the fu..

COMBUSTION AREA - Page 6

6 2. Remove filter cabinet door (See Fig. 18 and 19.) NOTE: It will be necessary to re- move 1 thumbscrew 3. Slide air filter out of filter cabinet. Keep dirty side up (if dirty) to avoid spilling dirt. See Fig. 20 and 21.) 4. Inspect the filter. If torn, replace it. NOTE: If washable filter that was shipped with the furnace has been re- placed by: a) Factory specified disposable media filter – Do not clean. If dirty, replace only with media filter having the same part number and size. Install with airflow di- rection arrow pointing towards blower. b) Electronic air cleaner (EAC) – Re-..

NOTE: - Page 7

7 21 22 23 BEFORE YOU REQUEST A “SERVICE CALL” BEFORE YOU CALL FOR SERVICE, CHECK FOR SEVERAL EASILY SOLVED PROBLEMS: • Check for sufficient airflow. Check the air filter for dirt. Check for blocked return-air or supply-air grilles. Be sure they are open and unobstructed. If this isn’t the cause, call your servicing dealer. If your furnace isn’t operating at all, check the following list for easily solved problems: • Is your thermostat set above room temperature? Is the HEAT mode selected? • Is the electrical power supply switch ON? Is the blower access door firmly in place? ..

INSTALLATION DATA - Page 8

8 New OM04-38 © 2000 Bryant Heating & Cooling Systems, 7310 W. Morris St. Indpls., IN 46231 PRINTED IN U.S.A. Catalog No. 5331-101 11-00 INSTALLATION DATA Date Installed Dealer Name Address City State/Province Zip/Postal Code Telephone FURNACE Product No. Model No. Serial No. AIR CONDITIONER OR HEAT PUMP OUTDOOR UNIT: Product No. Model No. Serial No. INDOOR COIL: Product No. Model No. Serial No.

..
MODEL 311AAV and 312AAV
DOWNFLOW/HORIZONTAL/
UPFLOW GAS FURNACE
NOTE TO INSTALLER:
This manual must be left with the
equipment user.
Multipoise
USER’S INFORMATION MANUAL
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not use
any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier, call the
fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
WARNING: If the information in this manual
is not followed exactly, a fire or explosion may
result causing property damage, personal injury
or loss of life.
!
Do not use this furnace if any part has been under
water. Immediately call a qualified service techni-
cian to inspect the furnace and to replace any part
of the control system and gas control which has
been under water.