IFIXIT Canon PowerShot SX120 IS Control Dial Replacement Instruction Manual
Use this repair guide to repair the Control Dial of a Canon PowerShot SX120 IS.
Written By: Destiny Bretado
INTRODUCTION
Hello everyone,
I hope you enjoy this walkthrough as it will guide you into fixing your control dial for the Canon PowerShot SX120 IS!!
TOOLS:
Phillips #00 Screwdriver (1)
iFixit Opening Tool (1)
Step 1 — Back Cover
Remove the double AA batteries before starting to disassemble. This will prevent you from permanently damaging your camera.
- Turn the camera to the side that the screen is showing.
- Remove the two black 3.4 mm screws with a Phillips #00 screwdriver.
Step 2
- Put the camera with the lens facing up, turn it to the side where the DC IN A/V OUT DIGITAL Cover and lanyard attachment are located.
- Remove the black 3.4 mm screws with a #00 Phillips screwdriver.
Step 3
- Put the camera with the lens facing up, turn it to the side where the Cover battery is located.
- Remove the black 3.4 mm screws with a #00 Phillips screwdriver.
Step 4
- Put the camera with the lens facing up, turn it to the side where the compartment of the battery (CR1220) for time/date is located.
- Unscrew the black 3.4 mm screws with a #00 Phillips screwdriver.
Step 5
- Put the camera with the lens facing down, turn it to the side where the
DC IN A/V OUT DIGITAL Cover and the silver lanyard attachment are located. - Open the DC IN A/V OUT DIGITAL cover.
- Remove the black 3.4 mm screw with a Phillips #00 screwdriver.
Step 6
- Turn the camera with the lens facing down.
Opening the camera can be challenging. Don’t get discouraged if it takes you a few tries before the camera is opened. - Use the blue opening tool to make lever. Insert the opening tool in the seam where the front case and the back case assemble.
- Carefully put pressure on the opening tool so the cover can gradually open.
- Slowly slide the opening tool along the gap and around the edge of the camera.
When you are dissembling the back cover, the DC IN A/V OUT DIGITAL cover will also disassemble and fall off.
Step 7
- This is a final picture of how it’s going to look when you disassemble the back cover.
- You will have 3 parts:
1. The camera
2. The DC IN A/V OUT DIGITAL Cover
3. The back cover.
Step 8 — Control Dial
- Once you have removed the back cover this is what the camera will look like.
- Locate the Control Dial.
Step 9
- Once the Control Dial is located carefully remove it using tweezers.
To reassemble your device, follow these instructions in reverse order.
© iFixit — CC BY-NC-SA
Read More About This Manual & Download PDF:
Documents / Resources
 |
IFIXIT Canon PowerShot SX120 IS Control Dial Replacement [pdf] Instruction Manual Canon PowerShot SX120 IS Control Dial Replacement, IS Control Dial Replacement, Replacement |
References
-
iFixit: The Free Repair Manual
-
store.ifixit.fr/products/ifixit-opening-tool
-
store.ifixit.fr/products/phillips-00-screwdriver
- User Manual
