INSTALL/REMOVAL INSTRUCTIONS:
IGNITION LOCK CYLINDER
926-055
926-055 Lgnition Lock Cylinder
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
REMOVAL/INSTALL OF IGNITION LOCK CYLINDER (926-055)
Chevrolet 1999–95, GMC 1999–95, Oldsmobile 1998–96, Pontiac 1999–97
PLEASE WEAR SAFETY GLASSES!
Removal Instructions
STEP 1: Disconnect negative battery cable.
STEP 2: Remove column tilt lever by pulling straight out, if equipped.
STEP 3: Remove column lower cover by removing mounting screws.
STEP 4: Remove upper column cover by removing retaining screw and lifting off of column.
STEP 5: Remove ignition lock cylinder by rotating to start position. While holding ignition in start position, insert small screwdriver or pick into release hole and pull lock from column.
Installation Instructions
STEP 1: Install ignition lock cylinder. If lock will not seat into housing use a screwdriver to align internal mechanism with new lock cylinder.
STEP 2: Reinstall steering column upper trim cover and screw.
STEP 3: Reinstall lower steering column trim cover and retaining screws.
STEP 4: Reinstall tilt lever if equipped.
STEP 5: Reconnect negative battery cable and verify proper operation of ignition lock.
We appreciate your opinions regarding this product!
Please call our Technical Assistant with any challenges or suggestions regarding the installation or operation of this product.
1-800-523-2492
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
©2018 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
Documents / Resources
 |
DORMAN 926-055 Lgnition Lock Cylinder [pdf] Instructions 926-055 Lgnition Lock Cylinder, 926-055, Lgnition Lock Cylinder, Lock Cylinder, Cylinder |
