HELLA MARINE 2LT 980 960-xxx Navi LED Anchor Light
IMPORTANT INFORMATION
Hella marine LED Navigation Lamps offer many advantages over conventional bulb lamps.
Significantly reduced power consumption, ultra long life and high tolerance to shock and vibration make the LED lamps the ideal choice for the harsh marine environment.
The Hella marine NaviLED®360 series are Precision Optical Instruments, tested and type approved to comply with international maritime regulations. They are covered by a 5 year warranty.
Marine Equipment Directive Declaration of Conformities are available at www.hellamarine.com.
SPECIFICATIONS
| Housing Material | UV resistant high impact plastic |
| Lens Material | Heavy duty Grammid® |
| Minimum Visible Distance | 2 Nautical Miles |
| Vessel Size | All vessels < 50m |
| Cable | Pre-wired with twin core marine cable |
| Operating Voltage | Multi volt TM 9-33V DC |
| Power Consumption | < 1W (0.08A @ 12V / 0.04A @ 24V) |
| Degree of Protection | IP 67 – Completely Sealed |
| Approvals | IMO COL REG 72, Wheel mark, UK MED, USCG 33 CFR 183.810, ABYC C-5 |
| ABYC C-5 Tested by | I manna Laboratory Inc (Date 6/07/2023) |
Electromagnetic Compatibility (EMC)
This LED lamp is an electronic device. The electrical circuits contain components that suppress possible interference, both emission as well as susceptibility, to the limits prescribed in international regulations.
Wiring Colour Coding
| Color | Connect to |
| Black | Negative (-ve) |
| Red | Signal (+ve) |
Wiring and Electrical Protection
LED modules are polarity conscious. This lamp is protected against reverse polarity connection, reverse polarity will not damage this product but will inhibit its function.
HELLA marine recommends wire connections be soldered, and heat shrink tubing applied to seal the joint. Each lamp must be protected against short circuit by a fuse rated at 3 amperes maximum.
Note: Do not attempt to open, no serviceable part inside.
Correct Positioning
NaviLED®360 Compact All Round / Anchor Lamps must be installed as follows:
When the lamp operates, the light should not be obstructed or concealed by masts, topmasts or structures, i.e. Installed on the highest point of a vessel so the light arc is unbroken.
All Round lamps must be positioned as close as practicable to the fore and aft centre line of a vessel. (see Fig.1)
The All Round white lamp on a power driven Vessel less than 12m in length shall be installed at least one meter higher than the sidelights.
The lamp must be installed so that the horizontal surface of the base is parallel to the vessel’s water line. (See Fig.2)
Installation Instructions
- Fixed Pole mount: Ensure mounting surface is flat and on the vessels centre line (see above). Use the provided screws to secure taking care not to over tighten.
- Fold-down Pole mount: A removable wedge is supplied for installations onto different surface cambers. Use the provided screws to secure taking care not to over tighten. Once mounted the base can be adjusted through 180 degrees, when the desired angled is reached secure by tightening the locking collar.
- Plug-in Pole mount: Mount base separately and connect wiring. Use the provided screws to secure taking care not to over tighten. Insert lamp into base and fix with locking collar. Ensure rubber cap, as provided, is used to cover socket when pole is removed. When the vessel is not in operation it is recommended to remove the lamp from the plug-in base and store it internally. Rinse the plug after each use, especially for salt water applications. Dry as much as practical, and ensure the rubber cap, as provided, is used to cover the socket when the lamp is removed.
To ensure long term safety, this NaviLED®360 lamp is equipped with a timing circuit.
Once the lamp has operated for a total time of 10,000 hours, the lamp activates ‘Service Mode’.
Service Mode is indicated by the lamp flashing at a rate of 60 flashes per minute for 15 seconds as soon as the lamp is switched on. This will occur for 15 seconds every time the lamp is switched on until the unit has operated for another 2000 hours.
After 2000 hours the Service Mode flash rate doubles to 120 flashes per minute for 15 seconds as soon as the lamp is switched on.
To ensure the lamp meets the light output criteria of its certification, Hella marine recommends the lamp be replaced as soon as it enters this 2000 hours Service Mode stage.
By normal recreational boating standards, even with regular night sailing, ‘Service Mode’ will hardly ever be reached.
Warranty
Congratulations! The product you have selected comes from HELLA – one of the world’s leading manufacturers of lighting products. The product comes with a 5 year warranty from end user purchase covering faults in materials, components or workmanship.
In the unlikely event that you should experience a confirmed warranty related problem with your purchase, HELLA will, at its discretion, either repair, replace or refund the purchase price of the product. Warranty services may be obtained by returning the product within the warranty period to the HELLA dealer where the product was originally purchased.
This warranty is in addition to and does not preclude any other rights or remedies available to the consumer under any local legislation related to the provision of goods or services.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
This warranty does not cover:
- Claim/s as a result of normal wear and tear or of any modifications and / or alterations to the product in any shape or form.
- Claim/s as a result of non-compliance of the assembly, service and operating instructions and/or any unfit or improper use.
- Any expenses incurred in the process of making the claim.
Note: For lamps sold in Australia, warranty services are provided by Hella Australia Pty Ltd., 4 Hargrave Place, Mentone, Victoria, 3194 Australia.
Customer Service
1800 061 729
email: custservice@hella.com
https://www.hella.com/hella-au/assets/media_global/IAM_Statement_of_Warranty.pdf
For general comments about Hella marine products please email techfeedback@hellamarine.com
Documents / Resources
 |
HELLA MARINE 2LT 980 960-xxx Navi LED Anchor Light [pdf] Instruction Manual 2LT 980 960-xxx Navi LED Anchor Light, 2LT 980 960-xxx, Navi LED Anchor Light, LED Anchor Light, Anchor Light |
Hella marine - Hella Marine 
