CLAS-logo

CLAS OC 9141 Cookie Cutter Kit For Parking Sensors

CLAS-OC-9129-Rear-Parking-Sensor-Punch-Tool-Kit-product

REAR PARKING SENSOR PUNCH TOOL KIT VW/BMW

CLAS-OC-9129-Rear-Parking-Sensor-Punch-Tool-Kit-fig-1

COMPONENTS

INTRODUCTION

It is compulsory to read this instruction manual before starting any kind of action. The proper operation and full compliance of this product’s performance is guaranteed only if all the instructions provided in this manual are closely adhered to. We guarantee that this product complies with the technical specifications described in this manual. The manufacturer shall not be held responsible for any improper uses other than those described herein. Use protective work gloves, protective footwear, hard hat, and safety goggles.

Misuse

  • This product should only be used as described in this documentation; any other use is considered improper.
  • The manufacturer accepts no responsibility for any damage caused by the incorrect or unreasonable use of the equipment.
  • Moreover, misuse shall also void the warranty. Take care of your tools
  • Be sure to store your tools in a clean state.
  • Place the tools inside their original package.

DESCRIPTION

The centering pin Ø 17,8 mm (VAS6614/5) ensures the correct fixing and alignment of the sensor supports.
The OEM numbers shown are used only for assigning technical data and fields of use!

INSTRUCTIONS

Always adhere to the vehicle manufacturer’s recommendations and repair instructions!

  • As a rule, the position of the sensors is marked by the manufacturer with markings on the inside of the bumpers (Figures 1+2).CLAS-OC-9129-Rear-Parking-Sensor-Punch-Tool-Kit-fig-2
  • Ensure the centering pin is perfectly suited to the sensor support (Fig.3).CLAS-OC-9129-Rear-Parking-Sensor-Punch-Tool-Kit-fig-3
  • From the outside, insert the appropriate centering pin into the hole of the newly cut bumper (Fig.4).
  • From the inside, place the sensor support directly on the pin (Fig.5).CLAS-OC-9129-Rear-Parking-Sensor-Punch-Tool-Kit-fig-4
  • Start fixing the support by following the procedure recommended by the manufacturer.

REAR PARKING SENSOR PUNCH TOOL KIT VW/BMW
If you need components or parts, please contact the reseller. In case of problems, please contact your authorized technician

Documents / Resources

CLAS OC 9141 Cookie Cutter Kit For Parking Sensors [pdf] Instruction Manual
OC 9141 Cookie Cutter Kit For Parking Sensors, OC 9141, Cookie Cutter Kit For Parking Sensors, Cutter Kit For Parking Sensors, For Parking Sensors, Parking Sensors, Sensors

References

Leave a comment

Your email address will not be published. Required fields are marked *