ECHOMASTER 2014-2021 Ford Transit Connect Wiring Harness for Backup Alarm
Thank you for purchasing the P-BUA-TRANSIT CONNECT.
WHAT’S INCLUDED
- Vehicle Specific Wire Harness (P-BUA-TRANSIT CONNECT)
COMPATIBLE ACCESSORIES
- 97dB Backup Alarm (BUA-97C)
- 97dB White Noise Backup Alarm (BUA-97WNC)
TOOLS REQUIRED
- 10mm Nut-setter
- Impact Drill
- Panel Removal Tool
- Fish Tape
- Knife
INSTALLATION INSTRUCTIONS
- STEP 1: Locate and disconnect the OEM tail lamp connector that is in the driver side rear corner of the vehicle.
- STEP 2: Install the P-BUA-TRANSIT CONNECT harness between the OEM connectors.
- STEP 3: Route the harness down the driver side rear corner cavity.
- STEP 4: Remove the pictured grommet, so that the harness may pass through. Use a fish tape to route the 2 pin connector of the harness down through the bottom of the rear corner cavity and below the vehicle
- STEP 5: Use an impact drill and 10mm nut-setter to install a compatible backup alarm on the underside of the vehicle
- Note: (2) 10mm TEK screws are provided with the compatible backup alarm
- STEP 6: Plug the backup alarm connector into the mating connector on the P-BUA-TRANSIT CONNECT harness. Use a knife to make a small cut in the grommet before it is re-installed
- STEP 7: Test the backup alarm.
CONTACT
- Phone: 866-766-2267
- E-Mail: support@aampglobal.com
- EchoMaster.com
Documents / Resources
ECHOMASTER 2014-2021 Ford Transit Connect Wiring Harness for Backup Alarm [pdf] Instruction Manual 2014-2021, 2014-2021 Ford Transit Connect Wiring Harness for Backup Alarm, Ford Transit Connect Wiring Harness for Backup Alarm, Transit Connect Wiring Harness for Backup Alarm, Wiring Harness for Backup Alarm, Backup Alarm |