2013 FORTE KOUP G 2.0 DOHC Manual Transaxle System
Removal
- Remove the following items;
- Engine cover (A). (Refer to “Intake and Exhaust system” in EM group.)
- Air cleaner assembly (B) and air duct (C) . (Refer to “Intake and Exhaust system” in EM group.)
- Battery and battery tray (D). (Refer to “Charging system” in EE group.)
- ECM (E) (Refer to “Engine Control System” in FL group.)
- Disconnect the back up lamp switch connector (B) and the vehicle speed sensor connector (A).
- Remove the ground cable from transaxle (A).
- Disconnect the select or shift cable assembly (B) after removing the pin (A).
- Remove the tube bracket bolt (A).
Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.8 ~ 15.9 lb-ft)
- Remove the transaxle upper mounting bolt (B-2ea) and the start motor mounting bolt (A-2ea).
Tightening torque:
[A,B] 42.2 ~ 54.0 N.m (4.3 ~ 5.5 kgf.m,31.1 ~ 39.8 lb-ft)
- Using the SST (09200-38001), hold the engine and transaxle assembly safely.
- Remove the transaxle support mounting bracket bolts (A-4ea).
Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.9 lb-ft)
- 9. Remove the under cover (A).
Tightening torque:
9.8 ~ 11.7 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.6 lb-ft)
- Remove the side cover (A).
- Remove the following items. (Refer to ” Drive shaft assembly ” in DS group.)
- Drive shaft assembly. (Refer to “Drive shaft assembly ” in DS group.)
- Sub frame assembly. (Refer to “Front suspension system” in SS group.)
- Remove the clutch release cylinder assembly(B) after removing the nuts (A-2ea).
Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.8 ~ 15.9 lb-ft)
- Remove the drive shaft cover (A).
- Remove the mounting bolts(A-4ea, B-2ea) of lower part of the transaxle, and the left side cover and remove the transaxle assembly by supporting it with a jack.
CAUTION
Be careful not to damage other system or parts near by when removing the engine and transaxle assembly.
Tightening torque:- 43 ~ 49 N.m (4.3 ~ 4.9 kgf.m, 31.1 ~ 35.4 lb-ft)
- 43 ~ 55 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)
Installation
- Installation is the reverse of removal.NOTE
- Adding Manual transaxle fluid. (Refer to “Manual transaxle system” in this group.)
Portions of materials contained herein are sourced from the Hyundai Kia Automotive Group Copyright 2011 – 2015 Service Repair Solutions, Inc.
Documents / Resources
 |
FORTE 2013 FORTE KOUP G 2.0 DOHC Manual Transaxle System [pdf] Instructions 2013, FORTE KOUP G 2.0 DOHC Manual Transaxle System, 2013 FORTE KOUP G 2.0 DOHC Manual Transaxle System, G 2.0 DOHC Manual Transaxle System, Manual Transaxle System, Transaxle System |
Direct-Hit -- Your Session has been Terminated 
