MoTrade LEXUS RC300 2015-2017 Carplay Android Auto Interface Instruction Manual
Android Auto Interface

LEXUS RC300 2015-2017

The interface is connected via a connection plug on the radio and a video cable on the display. It is estimated 30-60 minutes of work to connect the interface. No programming required.
Connecting plug

Step 1. Remove both panels from the center console (click off)
Unclip the short panels on both sides of the center console. Use removal tools. The panels are clicked.
Removing panel

Unscrew both long panels (two screws on each side) and gently stretch the panel from the narrow side and work towards the dashboard. Place the panels in a safe place. If necessary, use removal tools.
Unscrew both long panels

Step 2. Detach the center console (unscrew and unclip)
Remove the screw on the left side of the center console at the level of the gear lever. Pull the cover down from the gear knob and turn the knob off. Place a towel over the pin to protect other parts
Detach the center console

Pull up the top of the center console from the rear and pull it back as far as possible. If necessary, disconnect the plugs to make more space.
Pull up the top of the cente

Step 3. Loosen the radio (screws)
Remove the four 10 mm bolts from the radio and pull it forward to reach the plugs.

Step 4. Detach the air conditioning control panel
Unplug the air conditioning control panel and unplug the plug.
Detach the air conditioning

Step 5. Remove the display (screws)
Flip up the screen cover (start on the right). If necessary, use removal tools. Remove the two 10 mm nuts on the front. Pull the display up and place it in such a way that it cannot be damaged.
Remove the display
Remove the display

Step 6. Connect the plugs to radio and display
Pull the radio forward and connect the large and small plug of the interface. Press the clip of the grey part to release the large plug (see image). Transfer the two plugs that are released to the sockets.
Connect the plug

Swap the blue video plug of the display for the new plug and connect the old plug to the new socket. Plug the video cable straight down at the indicated position to get into the free space of the radio.
Plug the video cable

Step 7. Connect the interface
Connect the antenna, connection plug, video plug , microphone plug and any USBextension cable to the interface.

Step 8. Test the system
Connect (temporarily) the power button. Choose MEDIA to switch from the radio to the interface. Remove and forget the existing bluetooth connection to the car. Connect the phone to the bluetooth signal from the interface and turn on WIFI. Test the system with respect to graphics, sound, switching between radio and interface and backward. In case the screen systematically flashes every 20-25 seconds, the white wire should be cut at the indicated position (red arrow, second position top of plug). (This does not affect the original operation of the system)
Test the system

Step 9. Mount the interface
In case there is no space under or behind the radio, mount the interface behind the upholstery at the location of the left foot of the fellow passenger.

Mount the interface

Step 10. Build the system
Reconnect all components in reverse order. The system uses the existing microphone.

Step 1 1. Have fun!
Have fun

This manual has been compiled on the basis of experience and with the necessary care. No rights can be derived from it. Improvement tips/tricks are of course always welcome! (motrade@kpnmail.nl)

Documents / Resources

MoTrade LEXUS RC300 2015-2017 Carplay Android Auto Interface [pdf] Instruction Manual
LEXUS RC300 2015-2017 Carplay Android Auto Interface, 2015-2017 Carplay Android Auto Interface, Carplay Android Auto Interface, Android Auto Interface, Auto Interface, Interface

References

Leave a comment

Your email address will not be published. Required fields are marked *