dahl 620-31-04F Angle Dishwasher Elbow
Product Information
Specifications
- Model: 620-31-04F
- Usage: Compression fitting for copper pipe and plastic tube
- Material: Brass
- Installation: Compression fitting
Product Usage Instructions
Installation Process
- Turn off the water supply before starting the installation.
- Install the product according to the following steps:
- For Copper Pipe:
- Ensure the pipe is clean, de-burred, round, and cut square.
- Slide the nut, then the ring, and finally the valve onto the pipe.
- Tighten firmly using a small wrench, but do not over-tighten.
- For Plastic Tube:
- Follow the instructions provided by the tube manufacturer.
- A special ring, nut, or insert may be required for compression.
- For Hose:
- Tighten the hose firmly but avoid over-tightening.
- For Copper Pipe:
- Turn on the water supply and check for any leaks.
- Ensure compliance with local plumbing codes to avoid issues.
- Avoid exposure to corrosive agents to maintain product integrity.
FAQ
Q: Can I use pipe dope or PTFE tape with this product?
A: For compression on copper pipe, do not use pipe dope or PTFE tape. The pipe must be clean, de-burred, round, and cut square for proper installation.
Q: How should I tighten the compression fitting on a plastic tube?
A: Follow the instructions provided by the tube manufacturer as a special ring, nut, or insert may be required for compression on a plastic tube.
Q: What should I do if I encounter leaks after installation?
A: If leaks are detected after installation, ensure that all components are securely tightened. If issues persist, contact a professional plumber for assistance.
Usage Instructions
Instructions for 620-31-04F
- Turn off the water supply. Install product. Turn on the water supply, and check for leaks. dahl assumes no responsibility for failure due to improper installation.
- Abide by local plumbing codes. Do not expose to corrosive agents.
- COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape.
- The pipe must be clean, de-burred, round, & cut square. Slide nut then rings, then valve onto the pipe.
- Tighten firmly with a small wrench. DO NOT OVER-TIGHTEN.
Compression on the plastic tube:
- Follow the tube manufacturer’s instructions; a Special ring, nut, or insert may be required.
- HOSE: Tighten firmly. DO NOT OVER-TIGHTEN.
Documents / Resources
 |
dahl 620-31-04F Angle Dishwasher Elbow [pdf] Instructions 620-31-04F Angle Dishwasher Elbow, 620-31-04F, Angle Dishwasher Elbow, Dishwasher Elbow, Elbow |
