NOKIA-LOGO

Nokia (HS-26W) Wireless Headset

Nokia-(HS-26W)-Wireless-Headset

Introduction

You can connect the Nokia Wireless Headset (HS-26W) to a compatible phone that supports Bluetooth wireless technology. This allows you freedom to make and receive calls while on the move or in the office. Read this user guide carefully before using the headset. Read also the user guide for your phone, which provides important safety and maintenance information. Keep the headset out of reach of small children.

Bluetooth wireless technology

Bluetooth wireless technology makes it possible to connect compatible communication devices without using cables. A Bluetooth connection does not require that the phone and the headset be in line of sight, but both devices should be within 10 meters (30 feet) of each other. Connections can be subject to interference from obstructions, such as walls or other electronic devices. The wireless headset is compliant with Bluetooth Specification 2.0 supporting the following profiles: Headset Profile 1.1 and Hands-free Profile 1.0. Check with the manufacturers of other devices to determine their compatibility with this device. There may be restrictions on using Bluetooth technology in some locations. Check with your local authorities or service provider.

Overview

Nokia-(HS-26W)-Wireless-Headset-FIG- (2)

The headset contains the following parts as shown in the figure:

  • Power key (1) switches the headset on and off.
  • Earphone (2) relays the caller’s voice.
  • Indicator light (3) displays the current status of the headset.
  • Volume key (4) increases or decreases the earphone volume during a call. To mute or unmute the ongoing call, press the middle part of the volume key briefly.
  • Microphone (5) picks up your voice.
  • Answer/end key (6) answers or ends a call. This key can also be used for voice dialing, redialing, and switching an active call between the headset and the compatible phone.
  • Charger connector (7)

Before you can start using the headset, you must charge the battery and pair the headset with a compatible phone.

Note: Parts of the headset are magnetic. Metallic materials may be attracted to the headset, and persons with a hearing aid should not hold the headset to the ear with the hearing aid. Do not place credit cards or other magnetic storage media near the headset, because information stored on them may be erased.

Chargers and batteries

Check the model number of any charger before using it with this device. The Nokia Wireless. Headset (HS-26W) is intended for use with the AC-3, AC-4, and DC-4 chargers.

Warning: Use only batteries and chargers approved by Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty, and may be dangerous.

For availability of approved enhancements, please check with your dealer. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord.

Charge the battery

This device has an internal, non-removable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device.

  1. Connect the charger cable to the headset as shown in the figure.Nokia-(HS-26W)-Wireless-Headset-FIG- (1)
  2. Connect the charger to a wall outlet. The red indicator light is displayed during charging. Charging the battery fully may take up to 2 hours.
  3. When the battery is fully charged, the green indicator light is displayed.

Disconnect the charger from the wall outlet and the headset. The fully charged battery has power for up to 5 hours of talk-time or up to 150 hours of standby time. However, the talk and standby times may vary when used with different mobile phones, products that use a Bluetooth connection, usage settings, usage styles, and environments.
When the battery is running out of power, the headset beeps, and the red indicator light starts to flash.

Switch the headset on or off

To switch on, press the power key for 3 seconds. The headset beeps, and the green indicator light starts to flash quickly. The flashing is slower after the headset is connected to your phone.

To switch off, press and hold the power key for 2 seconds. The headset beeps, and the red indicator light is displayed briefly.

Pair the headset with a compatible phone

  1. Switch on your phone and the headset.
  2. Activate the Bluetooth feature on the phone, and set the phone to search for Bluetooth devices. See the user guide of your phone for instructions.
  3. Select the headset (Nokia HS-26W) from the list of found devices.
  4. Enter the passcode 0000 to pair and connect the headset to your phone. In some phones you may need to make the connection separately after pairing. See the user guide of your phone for details. You only need to pair the headset with your phone once.
  5. If the pairing was successful, the headset beeps and appears in the phone menu where you can view the currently paired Bluetooth devices.

Disconnect the headset from the phone to disconnect the headset from your phone (for example, to connect the phone to another Bluetooth device), do one of the following:

  • Switch off the headset.
  • Disconnect the headset in the Bluetooth menu of your phone.
  • Move the headset more than 10 meters (30 feet) away from the phone.

You do not need to delete the pairing with the headset to disconnect it. Reconnect the paired headset to your phone

To connect the headset to your phone, switch on the headset, make the connection in the Bluetooth menu of your phone, or press and hold the answer/ end key.

You can set your phone to connect with the headset automatically when the headset is switched on. To do this in Nokia phones, change your paired device settings in the Bluetooth menu.

Troubleshooting

If you cannot connect the headset to your phone, do as follows:

  • Ensure that the headset is charged, switched on, paired with and connected to your phone.
  • Ensure that the Bluetooth feature is activated on your phone.
  • Check that the headset is within 10 meters (30 feet) of your phone and that there are no obstructions between the headset and the phone, such as walls or other electronic devices.
  • If the headset stops functioning, although it has been charged, reset the headset by pressing the power key and the middle part of the volume key briefly, while the headset is plugged into a charger. This reset does not clear your settings (for example, pairing settings).

Basic use

  • Place the headset on the ear
  • Slide the headset onto your ear as shown in the figure.Nokia-(HS-26W)-Wireless-Headset-FIG- (3)

Call handling

To make a call, use your phone in the normal way when the headset is connected to your phone. If your phone supports redialing, press the answer/end key twice briefly while no call is in progress. If your phone supports voice dialing, press and hold the answer/end key when no call is in progress, and proceed as described in the user guide of your phone.

To answer a call, press the answer/end key, or use the phone keys. If the automatic answer function is set on in your phone, the phone automatically answers the incoming call after one ring.

To reject an incoming call, briefly press the answer/end key twice.To end a call, press the answer/end key, or use the phone keys.

Adjust the earphone volume
Press the volume key up to increase or down to decrease the volume during a call. To adjust the volume quickly, press and hold the key in the desired direction.

Mute or unmute the microphone
To mute or unmute the microphone during a call, press the middle part of the volume key briefly. A long tone is played. When the microphone is muted, the green indicator light flashes continuously.

Switch the call between phone and headset
To switch the call between the headset and a compatible Nokia phone, press and hold the answer/end key, or use the respective function in your phone.

Use the headset with several phones
You can pair the headset with up to eight phones but connect it to only one phone at a time.

The phone that was first paired with the headset is the default phone. If the headset is switched on within 10 meters (30 feet) of several paired phones, the headset tries to connect to the default phone. If the headset cannot connect to the default phone, the headset tries to connect to the last used phone. If the headset cannot connect to this phone either, start the connection from the desired phone.

Clear the settings

If you want to clear all the settings from the headset (for example, the list of paired devices), press and hold the power key and the volume key up for 10 seconds. After the settings are cleared, the headset beeps twice, and the red and green indicator lights alternate for several seconds.

Battery information

Your device is powered by a rechargeable battery. The full performance of a new battery is achieved only after two or three complete charge and discharge cycles. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device.

Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime. If left unused, a fully charged battery will lose its charge over time.

Use the battery only for its intended purpose. Never use any charger or battery that is damaged. Leaving the device in hot or cold places, such as in a closed car in summer or winter conditions, will reduce the capacity and lifetime of the battery. Always try to keep the battery between 15°C and 25°C (59°F and 77°F).

A device with a hot or cold battery may not work temporarily, even when the battery is fully charged. Battery performance is particularly limited in temperatures well below freezing. Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged. Dispose of batteries according to local regulations. Please recycle when possible. Do not dispose as household waste.

Care and maintenance

Your device is a product of superior design and craftsmanship and should be treated with care. The suggestions below will help you protect your warranty coverage.

  • Keep all accessories and enhancements out of the reach of small children.
  • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow the device to dry completely.
  • Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged.
  • Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics.
  • Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards.
  • Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and fine mechanics.
  • Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device.
  • Do not paint the device. Paint can clog the moving parts and prevent proper operation.

All of the above suggestions apply equally to your device, battery, charger, or any enhancement. If any device is not working properly, take it to the nearest authorized service facility.

FAQs

How do you use Nokia wireless headset?

Press and hold the Call key (#1) for two seconds, or until the red and blue indicator lights start to flash, to enter pairing mode. Your device should be set to Bluetooth. See your device’s user manual for further information. Choose your headset from the list of discovered devices.

Do Nokia headphones have a mic?

Nokia Power Earbuds: True Wireless with Charging Case; Up to 150 Hours of Playtime; Waterproof; Compatibility with All Bluetooth 5.0 Devices; Built-in Microphone; Crystal-Clear Sound with Enhanced Bass.

How do I know when my Nokia is fully charged?

When they are fully charged, the charging LED will always come on to show that. the charging case, then remove the headphones. Wait until you hear “Pairing” spoken as a voice prompt. Launch the Bluetooth device search on your smartphone.

How do I turn on my Nokia wireless headset?

Press and hold Call key (1) for 1.5 seconds to turn on (blue light). Press and hold the Call key (1) for two seconds to turn the power off (red light).

Is it okay to leave earbuds in case overnight?

Do not leave your charging case or earbuds plugged in continuously. Disconnect the cable once they are fully charged. Check the manual for any specific storage instructions if you want to put your headphones away for a week or longer.

How do I reset my Nokia earphones?

To do a soft reset, place the earphones in the charging case and wait for at least 10 seconds.

How do you pair a Bluetooth headset?

Make your Bluetooth gadget discoverable by turning it on. The method you use to make it discoverable is determined by the device. Choose Start > Settings > Bluetooth & devices > Add device > Bluetooth on your computer. Select the Bluetooth device, adhere to any further instructions that pop up, and then click Done.

Can you overcharge Bluetooth headset?

A protection board is incorporated into the lithium battery even if it has already failed. As a result, the voltage applied to the cell will never be higher than 4.2V. Long-term overcharging won’t occur. The Bluetooth headset battery can be safely charged on a large Bluetooth headset, therefore doing so won’t harm it.

How do I extend the battery life on my Bluetooth headset?

For a long-lasting battery, avoid placing your wireless headset in the hot sun or the bitter cold. When not in use, always remember to put the headset back into the charging base.

Do you have to charge wireless headset?

Chargers are required for wireless headphones. Wireless headphones are powered by lithium cells, which are found in rechargeable batteries, as opposed to wired headphones, which are powered by their cords. For the wireless Bluetooth headphones to work once they run out of power, they must be recharged.

How do I turn off my Nokia headset?

Turn off the earbuds by pressing and holding the multifunction key for eight seconds. The LED will then alternately glow blue and red (the LED will flash blue and red once and power off automatically).

How do I turn off my Nokia Bluetooth headset?

The Bluetooth headset’s primary button should be pressed and held for a few seconds. Your Bluetooth headset will suddenly turn off after a brief period of an LED light blinking on and off.

Can two Nokia Bluetooth headset  be used at once?

Android users must go to Bluetooth Settings and pair each Bluetooth speaker or set of headset individually. After connecting, click on Advanced Settings by tapping the three-dot icon on the right. If the “dual audio” option is not already selected, switch it on. Users should be able to connect to two devices at once thanks to this.

Why is my Nokia Bluetooth headset not turning on?

When Android Bluetooth stops working, you may occasionally only need to restart the device; this is especially true if it has been on for a while. So, all you have to do is toggle the Bluetooth connection on and off. The Bluetooth symbol will be visible; tap it to turn it off. To turn it on, tap it once more.

How long shall I charge my Nokia Bluetooth headset for the first time?

While the headset is on, avoid charging it. Before using the headset for the first time, it must must be charged for at least 30 minutes. Once the headset has received a full charge, it can be left in the charger without risk of damage.

References

Leave a comment

Your email address will not be published. Required fields are marked *