ideal-lux-logo

ideal lux PL4 D40 Ritz Ceiling Light

ideal-lux-PL4-D40-Ritz-Ceiling-Light-product

Dimension

E27 max 4 x 42W / 220~240V 50/60Hz – 8021696152875 BIANCO

ideal-lux-PL4-D40-Ritz-Ceiling-Light-fig-1

FEATURES

ideal-lux-PL4-D40-Ritz-Ceiling-Light-fig-2

INSTALLATION INSTRUCTION

ideal-lux-PL4-D40-Ritz-Ceiling-Light-fig-3 ideal-lux-PL4-D40-Ritz-Ceiling-Light-fig-4 ideal-lux-PL4-D40-Ritz-Ceiling-Light-fig-5 ideal-lux-PL4-D40-Ritz-Ceiling-Light-fig-6

SAFETY INSTRUCTIONS

ideal-lux-PL4-D40-Ritz-Ceiling-Light-fig-7

  1. This fitting is produced and tested by the strictest European safety standards (EN 60.598-1).
  2. This fitting cannot be disposed of as household waste. For disposal information ask the local authorities about how to collect it.
  3. As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician.
  4. If the external wire is damaged it has to be replaced exclusively by the manufacturer, distributor, or by a qualified electrician.
  5. Always isolate power before commencing installation, maintenance or repair.
  6. The luminaire contains certain parts which can be very hot.
  7. Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable.
  8. Always tighten the screws firmly to avoid contact problems.
  9. This fitting should only be installed indoors.
  10. Luminaires are not suitable for recessed on normally flammable surfaces.
  11. Luminaire is not suitable for direct mounting on normal flammable surfaces.
  12. This fitting is only suitable for fixing to the ceiling.
  13. This fitting is only suitable for fixing to the wall.
  14. The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain.
  15. Only use lamps that do not exceed the maximum specified wattage.
  16. Always observe the minimum distance between the lamp and the surface being lit, as shown in the icon. The lamp can cause a fire if the minimum distance is not observed.
  17. Auto-protected bulb. Only use bulbs marked with this symbol. Halogen bulbs get very hot. Wait until they cool down before replacing them.
  18. Cracked or broken safety glass has to be replaced immediately. Use only manufacturer-approved parts complying with regulations.
  19. Light source with not-substitutable light emitting diode (LED). Do not disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wipe with a damp cloth. Do not use solvents or strong detergents.
  20. This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
  21. Class I Electrical safety is guaranteed by the main insulation and an additional protective conductor (earthing) connected with the metal frame of the lamp. Earthing is obligatory.
  22. Class IL electrical safety is guaranteed by the main insulation and a double or reinforced insulation. Earthing not necessary.
  23. Class Ill Electrical safety guaranteed by a very low power supply (less than 50 Volt). Earthing excluded.
  24. Not protected.
  25. Protected against solid objects greater than 50 mm.
  26. Protected against solid objects greater than 12 mm.
  27. Protected against solid objects greater than 2,5 mm.
  28. Protected against solid objects greater than 1mm.
  29. Dust protected.
  30. Protected against dust infiltration.
  31. Not protected.
  32. Protected against vertically falling water drops.
  33. Protected against water drops falling with a maximum angle of 15° to the vertical axis.
  34. Protected against rain.
  35. Protected against splashing water.
  36. Protected against water jets.
  37. Protected against strong water jets.
  38. Protected against temporary immersion.
  39. Protected against prolonged immersion.
  40. Luminaire is not suitable for covering with thermally insulating material.
  41. Caution, risk of electric shock.
  42. Do not stare at the operating light source.

Product Specifications

  • Model: Ritz PL4 D40
  • Socket Type: E27
  • Maximum Wattage: 4 x 42W
  • Voltage: 220-240V, 50/60Hz
  • Color: BIANCO
  • Manufacturer: IDEAL LUX s.r.l.
  • Country of Origin: Italy

Frequently Asked Questions (FAQ)

Q: Can the LED light source be replaced?
A: The LED light source in this fixture is non-replaceable. Do not attempt to disassemble it.

Q: What should I do if the lamp does not turn on?
A: If the lamp does not light up, replace the fuse following the instructions provided in the manual.

Q: Is grounding mandatory for this lighting fixture?
A: Yes, proper grounding is mandatory based on the electrical safety class of the fixture. Consult a qualified electrician for installation.

IDEAL LUX s.r.l.

Documents / Resources

ideal lux PL4 D40 Ritz Ceiling Light [pdf] Instruction Manual
PL4 D40 Ritz Ceiling Light, PL4 D40, Ritz Ceiling Light, Ceiling Light, Light

References

Leave a comment

Your email address will not be published. Required fields are marked *