Verotti LV.2000 Luci Inox Shower Bath 
Mixer Installation Guide

Verotti LV.2000 Luci Inox Shower Bath Mixer Installation Guide

info@verotti.com
www.verotti.com

PARTS IDENTIFICATION

Verotti LV.2000 Luci Inox Shower Bath Mixer Installation Guide - PARTS IDENTIFICATION

INSTALLATION

Verotti LV.2000 Luci Inox Shower Bath Mixer Installation Guide - INSTALLATION

BODY INSTALLATION
  1. Flush the pipe work thoroughly prior to installation.
  2. Leave plastic cover in place and secure the body to the supporting timber noggin ensuring that it is orientated square and vertical
  3. Connect Hot + Cold water supply and outlet to the concealed valve
  4. Pressure test for leaks
  5. Sheet the wall using water resistant board or equivalent. Please refer to diagram above.
COVER PLATE INSTALLATION
  1. Once tiling is complete remove the plastic cover from the body sleeve
  2. Apply silicone to the back of the cover plate (Part 6) and slide over body flange (Part 8) creating a seal from the cover plate to the finished wall .
  3. Push Handle (Part 3 ) over Cartridge adaption and tighten grub screw (Part 2) firmly
  4. Screw Pin Lever (Part 1 ) into the handle housing and tighten firmly .

NOTE- It is the responsibility of the installer to ensure a waterproof seal is achieved between the product and mounting surface. If in doubt about the quality of the seal, remove the product and re-install any rotation, fix it to the wall using some glue.

IMPORTANT RECOMMENDATIONS FOR INSTALLATION
Installation should comply to AS/NZS3500.1 2003 or relevant local requirement.
Not suitable for gravity feed application.
Hot & cold water inlet pressures should be equal.

Verotti LV.2000 Luci Inox Shower Bath Mixer Installation Guide - WATER PRESSUREWATER PRESSURE
Operating static pressure is 150 – 500kpa. If pressure exceeds this, then an approved pressure limiting valve must be installed.

Verotti LV.2000 Luci Inox Shower Bath Mixer Installation Guide - PRE-FLUSHPRE-FLUSH
Always flush out the pipework before connecting any faucets. Damage caused to the faucet by debris coming through the pipework is not covered under warranty.

Verotti LV.2000 Luci Inox Shower Bath Mixer Installation Guide - WATER TEMPERATUREWATER TEMPERATURE
Maximum hot water temperature is 75 degree.

⚠ ATTENTION! Failure to do so will void the warranty.

Verotti LV.2000 Luci Inox Shower Bath Mixer Installation Guide - WaterMark Logo

Documents / Resources

Verotti LV.2000 Luci Inox Shower Bath Mixer [pdf] Installation Guide
LV.2000 Luci Inox Shower Bath Mixer, LV.2000, Luci Inox Shower Bath Mixer, Shower Bath Mixer, Bath Mixer

References

Leave a comment

Your email address will not be published. Required fields are marked *