CANDO-logo

CANDO 07-7067 Pneumatic Stool with Back

CANDO-07-7067-Pneumatic-Stool-with-Back-product

What’s In The Box

CANDO-07-7067-Pneumatic-Stool-with-Back-fig- (1)

Dimension

CANDO-07-7067-Pneumatic-Stool-with-Back-fig- (2)

Assembly Instructions

  1. Remove the protective cap from the Pneumatic Cylinder. (Fig. 1) Place the seat upside down near the edge of a sturdy table. Put the button end of the pneumatic cylinder into the opening in the metal flange on the bottom of the seat. (Fig. 2) Use minimal force to press the cylinder into the opening.CANDO-07-7067-Pneumatic-Stool-with-Back-fig- (3) CANDO-07-7067-Pneumatic-Stool-with-Back-fig- (4)
  2. Point the backrest towards the floor and slide the end of the L-shaped shaft into the flange on the bottom of the seat. (Fig. 3) Once the two (2) holes are lined up, insert the knob and twist it until it is tight.CANDO-07-7067-Pneumatic-Stool-with-Back-fig- (5)
  3. Turn the 5-point base upside down. Press one (1) caster into each of the ends of the 5- 5-point base. (Fig. 4)CANDO-07-7067-Pneumatic-Stool-with-Back-fig- (6)
  4. Turn the 5-point base over and place it on level ground so it is resting on all 5 casters. Place the bottom end of the pneumatic cylinder into the center opening in the 5-point base. (Fig. 5) Use minimal force to press the cylinder into the opening.CANDO-07-7067-Pneumatic-Stool-with-Back-fig- (7)
  5. Carefully sit down on the seat* until the cylinder locks into place.
  6. Using the lever under the seat, you can adjust its height as needed. Height adjusts from 17.91″ (45.5 cm) to 23″ (58.5 cm). 5.25″ (13.3 cm) total adjustability.

Cleaning Instructions

This item can be cleaned/sanitized using soap and water or a disinfectant, wipes/spray. Cleaner/sanitizer should be applied after every use. Bleach and any other commercial disinfectants, such as Oxivir, is not permitted.

CAUTION:

  • Maximum Weight Rating – 300 lb (136 kg)
  • If components are damaged or missing, contact your dealer immediately. DO NOT use substitute parts.
  • You need to weigh at least 90 lb (41 kg) to adjust the height of the seat.

Fabrication Enterprises Inc

  • 250 Clearbrook Road, Suite 240 Elmsford, NY 10523 (USA)
  • tel: +1-914-345-9300 • 800-431-2830
  • fax: +1-914-345-9800 • 800-634-5370
  • FabEnt.com.

AJW Technology Consulting GmbH Breite Strasse 3 40213 Dusseldorf Germany.

WARNING:
Cancer and Reproductive Harm – www.P65Warnings.ca.gov

© 2023 FEI, all rights reserved. Can Do and Sil are trademarks of Goldberg.

Made in China.

Documents / Resources

CANDO 07-7067 Pneumatic Stool with Back [pdf] Installation Guide
07-7067 Pneumatic Stool with Back, 07-7067, Pneumatic Stool with Back, Stool with Back, Back

References

Leave a comment

Your email address will not be published. Required fields are marked *