PACIFIC ENERGY WODC.BLOW Blower Kit Blower Fan Heater Instruction Manual
Blower Assembly Installation (all models):
- Loosen the 2 screws at the center of the blower.
- Install the temperature snap-switch assembly onto the blower by placing the bracket over the screws.
- Tighten the screws.
- Ensure that the two wires are connected to the temperature snap switch.
- Slide the temperature snap-switch assembly up into the space between the rear shield and the firebox, ensuring that the temperature snap-switch contacts the firebox.
- Install the two screws through the flange of the blower into the rear hied.
- Plug the power supply cord in and check blower operation.
When the top air side deflectors are installed on the Vista or Summit freestanding wood stoves, they will increase the flow of air toward the front of the stove. They are not intended for use on the Super 27 wood stove.
Blower Assembly Installation (Vista & Summit Models):
- Place the top air side deflector in the gap between the rear shield and the back of the stove as shown in Fig. #1.
- Insert a #8×1/2” screw into the hole on the side of the rear shield.
- Slide the deflector up so that it fi ts snugly with the underside of the rear shield as shown in Fig. #2.
- Tighten the screw.
- Repeat the procedure on the opposite side of the stove.
Documents / Resources
 |
PACIFIC ENERGY WODC.BLOW Blower Kit Blower Fan Heater [pdf] Instruction Manual WODC.BLOW Blower Kit Blower Fan Heater, WODC.BLOW, Blower Kit Blower Fan Heater, Kit Blower Fan Heater, Blower Fan Heater, Fan Heater |
