REMINGTON MB7050 Hair Clipper and Beard Trimmer Kit Instructions
Troubleshooting Steps
CLEANING AND MAINTENANCE
Care for your appliance to ensure a long lasting performance. We recommend that you clean it after each use.
AFTER EACH USE
- Brush any accumulated hairs from the trimmer and attachment heads.
- The easiest and most hygienic way to clean the trimmer is under the tap.
- Place one or two drops of oil on the blades. Turn the appliance on to distribute the oil evenly, wipe off any excess oil.
REPLACING THE FOILS AND CUTTERS
To ensure continued high quality performance from your shaver, we recommend the foils and cutters are replaced regularly.
Signs that your foils and cutters need replacing
- Irritation: as foils get worn, you may experience skin irritation.
- Pulling: as the cutters wear, your shave may not feel as close and you may feel the cutter pulling your hair.
- Wear through: you may notice that the cutters have worn through the foils.
- Remove the shaving head assembly by pressing the shaver head release buttons on both sides of the shaver.
- Insert a flat bladed screwdriver between the sides of the foil screen and the head assembly and pull away from the notches.
- To reassemble, slide the foil into the shaving head and click into position.
- Hold the foil by the plastic frame to prevent damage. Replacing the cutters
- Remove the shaving head assembly by pressing the shaver head release buttons on both sides of the shaver.
- Grasp the cutter between your thumb and forefinger and pull upwards.
- Snap the new cutter into the oscillator tip.
- Note: DO NOT press on the cutter ends as this may cause damage.
BATTERY REMOVAL
We strongly recommend that a professional removes the rechargeable battery. Parts of the shaver case, and tools have sharp edges and may cause injury if not handled correctly.
- The rechargeable battery must be removed from the appliance before it is scrapped.
- Disconnect the charging adapter before removing the battery.
- Ensure the device is discharged of all power. To do this, switch it on and allow it to run until it stops.
- Remove the T-blade.
- Pry and remove the top decorative panel and top housing.
- Unscrew the 4 screws on the inner housing, and take off the top inner housing.
- Take out the assembly of battery and printed circuit board.
- Disconnect he battery from the circuit board.
- Used batteries must be removed from the appliance and disposed of at an appropriate official recycling/collection point.
- Do not attempt to operate the shaver once you have opened it.
Documents / Resources
 |
REMINGTON MB7050 Hair Clipper and Beard Trimmer Kit [pdf] Instructions MB7050 Hair Clipper and Beard Trimmer Kit, MB7050, Hair Clipper and Beard Trimmer Kit, Clipper and Beard Trimmer Kit, Beard Trimmer Kit, Trimmer Kit, Kit |
